MARMOT flux MDI701

Standard (SnPb) soldering » MARMOT fluxes for hand and wetting soldering » MARMOT flux MDI701

Technical Data Sheet

MDI701

 

Product name: 

 MARMOT® Flux MDI701

Description and key properties:

 

  • Organic flux for soft soldering varnished wires with solderable coating
  • For hand soft soldering in electronics with standard SnPb
    and lead-free solders
  • Activated without content of halides
  • For aviation, military devices and for soldering color metals

Operating manual:

Applicable by suitable tool or dip soldered part in the flux

 

 

 

 

 

Technical specification:

Corresponds to norm:

Classification:

 

EN 29454-1     

1.1.3.A

Fully complies EU directive - RoHS

DIN

F-SW-27

 

J-STD

ROM0

Form

Liquid

Aroma

After cyclic ketone

Density

0,9 - 1,1

kg/dm3

Melting point

 

C

Boiling point 

155

C

Color

Transparent blue-gree

Spread factor – USA methodology MIL-F-14256D

 

%

Spread areal – EU methodology

 

mm2

Absolute corrosive  effect on  Cu mirror

 

- EN 29455-5 (ISO 9455-5:1992)

 

- USA method MIL-F-14256D:

 

corrosive  effect tropical humidity 21 days

Without corrosion - Complies excellent

Insulation resistance :

 

 

5kV distance 1mm

 

M ohm

PCB  distance 1 x 1mm

 

M ohm

electrical breakdown distance 1mm

 

KV

Soluble in:

Hot water

No limits

g/lit.

 

 

Recommended thinner :                

Isopropyl alcohol,

Recommended  cleaner:

Isopropyl alcohol and other alcoholes

Used methodology conform  the norm MARMOT,  M01-3 for led free solders M01.1

Other proprieties: Electro insulation properties of the flux gain after soldering or after drying. Flammable liquid.

*For aviation and military devices is recommend cleaning, for other usage apply cleaning if there is risk of electrical leak. In all other application where the small residuum of the flux after soldering does not affect the product is not necessary to apply cleaning.

It is necessary to examine influence of the flux residue after soldering on soldered device.

 

Issued:

22.7.2008

Revised

25.01.2013

         

 

11.0.

Safety and health protection

 

 

11.1.

Long lasting and repeated contact with skin can cause irritation and sensibility, therefore is necessary to avoid direct contact.  In case when it is not possible exclude possibility of direct skin contact, the workers must wear suitable personal protective equipment. Work area must be ventilated. Do not drink or eat during work. Do not use naked flame. After work, hands should be washed with soap and warm water and cared with protective cream.

 

 

11.2.

First Aid

 

Inhalation – in case of excessive inhalation of flux fumes emitted during soldering, remove affected person to fresh air.

Ingestion – in case of accidental Ingestion, wash out mouth with water and give enough pure water to drink.

Skin contact – in case of skin contact, wash the place with soap and warm water.

Eye contact – in case of eye contact, flush the eyes immediately with plenty of water.

In case of large health damage or eyes contact, seek medical attention. 

 

11.3.

Above mentioned precautions are recommended for health protection of the workers, obligatory measures are described in Safety Data Sheet (SDS) - if released, and do not substitute internal safety regulations of final customer.