MARMOT flux MTV009B

Standard (SnPb) soldering » MARMOT fluxes for hand and automated soldering » MARMOT flux MTV009B

Technical Data Sheet

MTV009B

 

Product name: 

 MARMOT® Flux MTV009B

Description and key properties:

 

  • Fully inorganic flux for hand and automated soft soldering
    with high reduction effect
  • Activated by halides based on zinc-amine complex
  • For soft soldering in engineering with standard SnPb and lead-free solders
  • For soft soldering by naked flame with high working temperature
    range 180°C to 750°C
  • The flux does not contain any organic components therefore
    does not carbonize during soldering
  • Useable everywhere  when water cleaning is applicable
  • High efficiency not only with color metals  but even with steel,
     nickel and noncorrosive steel  
  • It is mainly appointed as a filling of the cored wire solder

Operating manual:

It is exclusively filled into the standard Tin-Lead or Lead-Free multicored wire solders

 

 


 

Technical specification:

Corresponds to norm:

Classification:

 

EN 29454-1     

3.1.1.B

Fully complies EU directive - RoHS

DIN

F-SW-12

 

J-STD

IRH1

Form

Solid

Aroma

Odorless

Density

1,8+ - 0,2

kg/dm3

Melting point

120

C

solidification point

96

C

Color

Colorless - light yellow

Spread factor – USA methodology MIL-F-14256D

76-82

%

Spread areal – EU methodology

150

mm2

Absolute corrosive  effect on  Cu mirror

Not applicable

- EN 29455-5 (ISO 9455-5:1992)

Not applicable

- USA method MIL-F-14256D:

Not applicable

corrosive  effect tropical humidity 21 days

Not applicable

Insulation resistance :

 

 

5kV distance 1mm

Not applicable

M ohm

PCB  distance 1 x 1mm

Not applicable

M ohm

electrical breakdown distance 1mm

Not applicable

KV

Soluble in:

Hot water

without limits

g/lit.

 

 

Recommended thinner :                

 

Recommended  cleaner:

Hot water, Isopropyl alcohol.

Used methodology conform  the norm MARMOT,  M01-3 for led free solders M01.1

Other proprieties: Solid substance read safety data sheet if released

Apply water cleaning after all kind of soldering.

It is not suitable for soldering joints on plastic insulant (PCB) can leave conductive traces

 

Issued:

22.7.2008

Revised

25.01.2013

         

 

11.0.

Safety and health protection

 

 

11.1.

Long lasting and repeated contact with skin can cause irritation and sensibility, therefore is necessary to avoid direct contact.  In case when it is not possible exclude possibility of direct skin contact, the workers must wear suitable personal protective equipment. Work area must be ventilated. Do not drink or eat during work. Do not use naked flame. After work, hands should be washed with soap and warm water and cared with protective cream.

 

 

11.2.

First Aid

 

Inhalation – in case of excessive inhalation of flux fumes emitted during soldering, remove affected person to fresh air.

Ingestion – in case of accidental Ingestion, wash out mouth with water and give enough pure water to drink.

Skin contact – in case of skin contact, wash the place with soap and warm water.

Eye contact – in case of eye contact, flush the eyes immediately with plenty of water.

In case of large health damage or eyes contact, seek medical attention. 

 

11.3.

Above mentioned precautions are recommended for health protection of the workers, obligatory measures are described in Safety Data Sheet (SDS) - if released, and do not substitute internal safety regulations of final customer.